#Vintage martin guitar serial numbers serial number#
#Vintage martin guitar serial numbers full#

Martin has been making some of the best flat top acoustic guitars since the (the same results should be seen if not, the neck has a 'twist' to it). You should be able to put a medium guitar Note the distance between the bottom of the low-E Then hold the low-E string down at theДЎst and 14th frets. To check neck straightness on a guitar, first This means the neck better be straight, otherwise an expensive Regarding truss rods, all vintage Martin instruments post-1934 have *non-adustable* Is taken from the bottom of the low-E string, to the top of the 12th fret. 'string action' is more than 3/16 inch (5 mm) at the 12th fret, Generally speaking, most players would agree if the The value of the guitar (and in fact can make it more valuable, as the guitar Neck at a slightly increased angle, which lowers the string action). This can only be fixedД¬orrectly by a 'neck set' (removing the neck on the guitar, and refitting the The result, making the guitar very difficult to play. With the 'neck set' on many of their guitars before 1970. On Martin guitars, this is a really big deal. On flat top martins, the most common modifications are a replaced bridge, replaced Specs for a particular year guitar in this web page, and compare to your instrument. Modifications can often be determined by looking at the model

Modifications (any modifications),ДЄre a bad thing in the eyes of a collector. Originality of an instrument is very important.

#Vintage martin guitar serial numbers full#

Section for a full list of these suffixes. For example,ДЄ 'T' after the style number indicates a Tenor guitar. The style number too, giving some additional info about the instrument. Stamped all flat top guitars with the style number, directly after the body size (andДЄbove the serial number). The more fancy (and collectible) the instrument. Nearly all Martin instruments come in different styles. The body size is to use the flat top guitar body size chart below.Д«ody sizes, pretty much from smallest to biggest, include O, OO, OOO, OM, D.

For flat top guitars madeД«efore October 1930, the easiest way to figure out This makes identifyingД«ody size on October 1930 and later guitar very easy.

#Vintage martin guitar serial numbers serial number#

Stamped the guitar body size right above the serial number inside the guitar. So important to identify on a Martin flat top guitar. The better and more collectible the guitar. Martin flat top guitars were made in various sizes. Flattop: a flat top to the guitar, and a single round sound hole under the strings.Archtop: an arched top to the guitar with either a round soundhole, or two 'f' holes.Uke size instruments with eight strings are Taropatches. Uke size instruments with ten string are Tiples. If a guitar only has four strings (and is not a ukulele), Have an arched top, with a 'trapeze' style bridge. Or two 'f' style sound holes (one on each side of the top of the body), and MartinДЄlso made some archtop models during the 1930s.

Sound hole in approximately the center of the flat top of the guitar, with a 'pin' style bridge. Most Martin guitars made are 'flat top' models. See the serial number section below for details. This number can be used to determine theД®xact year of manufacture. There is a serial number inside the guitar. Every Martin guitar made in 1898 and later,

Oringinality (have any of the parts, such as the bridge or tuners, been changed or modified?).

The body style (for flattop guitars generally 15, 16, 17, 18, 21, 28, etc.).

The body size (for flattop guitars generally O, OO, OOO, OM, D, etc.).

The type of guitar (flattop, archtop, uke, etc).

The year it was made (using the serial number, which exists on all.

Martin Playability (Neck Sets and Bridges)Д«efore much can be determined about a Martin guitar,.

General specifications, serial numbers, model information. Vintage Guitars Info - Martin collecting vintage martin guitarsД¬ollecting vintage Martin guitars and ukes.